Deep Learning IIT Ropar Week 10 Nptel Assignment Answers
Are you looking for the Deep Learning IIT Ropar Week 10 NPTEL Assignment Answers 2025 (jan-Apr)? You’ve come to the right place! Access the most accurate and up-to-date solutions for your Week 10 assignment in the Deep Learning course offered by IIT Ropar.
Table of Contents
Deep Learning IIT Ropar Week 10 Nptel Assignment Answers (Jan-Apr 2025)
Course Link: Click Here
1) The CSMA/CD protocol, predominantly used in Ethernet, addresses which of the following challenges?
a) Efficient encoding and decoding of data signals
b) Synchronization of devices in wireless networks
c) Detection and management of data collisions in shared media networks
d) Guaranteeing data delivery across multiple broadcast domains
2) Which MAC technique is most suitable for bursty traffic with sporadic transmissions?
a) Synchronous MAC with reserved slots
b) Asynchronous MAC with round-robin allocation
c) Token passing in ring topology
d) Contention-based asynchronous MAC
3) In Go-Back-N ARQ, why must the size of the sender’s window be less than 2m, where m is the number of bits in the sequence number?
a) To prevent out-of-order frames from being accepted by the receiver
b) To allow cumulative acknowledgments to function correctly
c) To ensure the receiver’s window size can accommodate all pending frames
d) To avoid ambiguities in the sequence numbers during retransmission
Deep Learning IIT Ropar Week 10 Nptel Assignment Answers
4) What is the minimum frame size for Ethernet (IEEE 802.3), and why is it important?
a) 46 bytes, to prevent collisions from being detected too late
b) 64 bytes, to ensure collision detection within the frame transmission time
c) 512 bytes, to maximize bandwidth efficiency
d) 1500 bytes, to support large data payloads
5) In a Selective Repeat ARQ system with a 4-bit sequence number and a sender’s window size of 8, what is the minimum size of the receiver’s buffer to prevent loss of out-of-order frames?
a) 4
b) 8
c) 16
d) 32
6) A wireless CSMA/CA network uses a backoff algorithm with a contention window size that doubles after each collision. If the initial contention window size is 32, what is the maximum contention window size after 4 collisions?
a) 128
b) 256
c) 512
d) 1024
7) In a shared 75 kbps channel, each station transmits a 20-bit frame every 2000 ms. If the network uses Slotted Aloha, what is the maximum number of stations that can be supported?
a) 7500
b) 2775
c) 7000
d) 5000
Deep Learning IIT Ropar Week 10 Nptel Assignment Answers
8) Consider a CSMA/CD network where the frame transmission time Tf is much larger than the propagation delay Tp. Which of the following factors affect the efficiency of the network?
(i) Frame size
(ii) Propagation delay Tp
(iii) Backoff time after a collision
(iv) Total number of stations
a) (i), (ii) and (iii)
b) (ii), (iii) and (iv)
c) All are True
d) All are False
9) In a round-robin MAC technique, a network has 10 stations, and each station gets a time slot of 2 ms. If a station has a data frame of 2 KB to transmit, and the transmission rate is 1 Mbps, how many rounds will it take for the station to complete its transmission?
a) 10
b) 12
c) 16
d) 20
10) A network administrator is analyzing a collision on a traditional Ethernet network using CSMA/CD. They observe the following sequence:
(i) A node transmits a frame after sensing the medium is free.
(ii) A collision occurs, detected by voltage fluctuations.
(iii) A jam signal is transmitted, and the node applies a backoff algorithm.
If the backoff limit is reached without successful transmission, what should the node do next?
a) Retry immediately without further sensing
b) Send another jam signal and continue to back off indefinitely
c) Abort the transmission and report a failure
d) Switch to a synchronous MAC protocol
Deep Learning IIT Ropar Week 10 Nptel Assignment Answers
More weeks of Deep Learning: Click Here
More Nptel Courses: https://progiez.com/nptel
Deep Learning IIT Ropar Week 10 Nptel Assignment Answers